Coolant Vacuum Purge & Refill Tester T&E Tools 12275N NEW automotive

T & E Tools Coolant Vacuum Purge & Refill Tester 12275N

Calculate Shipping

Free Shipping Offer for orders over $150 - $0.00 (ETA: 4 days)
Free Shipping Offer is only Valid For orders over $150 and weigh under 5KGs ******************************************************************************************************** • Free shipping is only valid to delivery destinations within Australia. • The order value is not inclusive of any quoted freight charges or installation charges. • Remote areas may be charged a small surcharge Please contact us if ordering from a remote areas. This method can not be used for delivery to PO Boxes or Parcel Lockers

Description

Coolant Vacuum Purge & Refill Tester T&E Tools 12275N

After draining the radiator the tester will evacuate all the air from the system enabling the radiator to be refilled without creating air locks and prevents from the engine overheating
Select the suitable size rubber bush to fit radiator neck then tighten tester to the neck securely
Connect cooling system adaptor to the vacuum pump fitting then connect to shop air and open switch valve
Allow air to reach a vacuum level between 20-25inHG (50-60cm/HG) of mercury
Close the switch valve and take off the vacuum pump fitting
Connect coolant hose to the cooling system adaptor then open the switch valve
The coolant hose will fill with coolant and flow into the radiator from the container until gauge pressure reaches zero
If the radiator is not completely filled a further top up may be required
Related Items: 12275GAUGE Gauge Only for Coolant Evacuator & Test System 12275N Coolant Vacuum Purge & Refill Tester G03 Standard Bayonet Tank Adaptor GT4 Radiator Expanding Adaptor RT-919A Radiator Pressure Test Set RT-919C Radiator Pressure Test Set (extra Adapt) RT919-09 Adjustable Seat (50mm) RT919-10 Adjustable Seat (35mm) RT919-11 Adjustable Seat (27mm) RT919-12 Tank Adaptor (31mm) RT919-83 Expanding Taper Adaptor (35-50mm) RT919-P1 Hand Pump RT919-T1 Automatic Air Inlet Pump
.

Warranty

T&E Tools manufactures and markets Professional Hand Tools, Specialty Service Tools and Workshop Equipment all to represent quality and value as a matter of policy. All T&E Tools are engineered and manufactured to the highest quality standards and are warranted to be free of defects in workmanship and materials. Any T&E Hand Tool, Speciality Service Tool or any piece of Workshop Equipment, which fails during its normal useful life to perform satisfactorily, will be repaired or replaced at no charge. This warranty does not extend to altered, abused, badly worn product, or an item used for a purpose other than for which it was intended. T&E Tools Pty. Ltd. is not liable for incidental or consequential costs or losses incurred by the product, purchaser or user. Items such as pullers can be subjected to high torque loads. They require sufficient lubrication to forcing screw threads to prevent binding. Torque wrenches or multipliers that are found to be defective in material or workmanship must be returned to the T&E Tools repair centre, for evaluation before any repair or replacement is given. T&E Tools Pty. Ltd. reserves the right to repair or replace product, if a defect in material or workmanship is found. Many speciality tools are designed in a manner that require usage as set out in the instructions supplied and care should be taken to insure the method of operation is followed correctly.